2023 NEW PRODUCTS WINDSHIELDS & FAIRINGS AUDIO, COMMUNICATION & MOUNTS SADDLEBAGS & LUGGAGE SEATS & SISSY BARS FUEL/AIR SYSTEMS EXHAUST TRANSMISSION & DRIVELINE ENGINE GASKETS & SEALS LIGHTING ELECTRICAL HANDLEBARS, CONTROLS & MIRRORS CABLES TANKS & OIL FILTERS BRAKES DASHES & GAUGES FENDERS & LICENSE PLATE FRAMES HARDWARE, COVERS & GENERAL FRAMES & SUSPENSION FOOTRESTS & FLOORBOARDS WHEELS & AXLES dragspecialties.com All part numbers in BLUE are new for 2023. SECTION 7 588 See OLDBOOK For Early Model Applications DISCLAIMER: NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES. SEE PAGES 5 AND 6 FOR IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PART # DESCRIPTION SUG. RETAIL WITH O2 SENSORS 1020-2491 For 14-20 Dresser models $629.99 1020-2485 For 10-13 Dresser models 629.99 1020-2483 For 07-09 Dressers, 07-11 FXST/FLST (except 07-11 CVO models), 06-11 Dyna Glide, 08-11 V-Rod, and 07-13 XL models 629.99 1020-2489 For 12-17 FXST/FLST and 12-17 Dyna Glide models 629.99 1020-2495 14-22 XL models (except 21-22 Sportster S/RH1250S, 22 Nightster/RH975) 629.99 1020-2487 For 12-17 V-Rod models 629.99 1020-2493 For 15-20 XG 500/750 models 629.99 WITHOUT O2 SENSORS 1020-2492 For 14-20 Dresser models 315.54 1020-2486 For 10-13 Dresser models 315.54 1020-2484 For 07-09 Dressers, 07-11 FXST/FLST (except 07-11 CVO models), 06-11 Dyna Glide, 08-11 V-Rod, and 07-13 XL models 315.54 1020-2490 For 12-17 FXST/FLST and 12-17 Dyna Glide models 315.54 1020-2496 14-22 XL models (except 21-22 Sportster S/RH1250S, 22 Nightster/RH975) 315.54 1020-2488 For 12-17 V-Rod models 315.54 1020-2494 For 15-20 XG 500/750 models 315.54 TARGET TUNE • Allows the factory ECM to interpret and use wideband O2 sensor signals • Target fuel table from the calibration is achieved in real time • Retains OEM closed loop and achieves adaptive fuel control strategy • Learns and uses VE table corrections as you ride • Does not interfere with dealer diagnostic/service tools • Includes OEM style connectors to plug into factory O2 harness, either 2- or 4-pin versions • Available with or without O2 sensor PART # DESCRIPTION SUG. RETAIL 1020-15591 For 14-20 Dressers, 12-17 FXS/FLS/FLST, Dyna Glide and 12-17 XL models w/ CAN-bus 6-pin connector $531.10 1020-11171 For 10-13 Dresser models w/ 12mm O2 sensor (except FXST/FLST, Dyna Glide 4-pin connector models) 531.10 1 Requires installation of two 18mm sensor bungs (included). AUTOTUNE KITS FOR POWER COMMANDER V • Plugs directly into the Power Commander V with a single cable • Includes 18mm O2 sensors and power connector that plugs into the bike’s harness • Makes automatic fuel adjustments • User can specify what air/fuel ratio to make each rpm and throttle position percentage combination • Makes it possible to adjust cruise for best fuel economy as well as larger throttle openings for peak power • Base settings included for air/fuel ratios, but are fully adjustable if need be • Made in the U.S.A. NOTE: Because of possible clearance issues, some aftermarket exhaust systems may require modifications or relocation of their sensor bungs. PART # DESCRIPTION SUG. RETAIL 1020-2371 POD-300 digital display $315.54 POD-300 DIGITAL DISPLAY • Real-time fuel adjustment • Display channels real-time: rpm, TP, map position (when using map switch), duty cycle, fuel exchange, ignition change and wideband air/fuel ratio (with WB2 or AutoTune connected) • Weather resistant for use in all conditions • Log channels saved to internal memory and can be viewed/ analyzed with Dynojet’s powercore software • High-contrast display, viewable in sunlight • Includes CAN cable for attachment to Power Commander V, AutoTune and Wide Band Power Commander NOTE: Not for use with Power Commander III USB. 1020-2483 1020-1117
RkJQdWJsaXNoZXIy OTcxOTk3