BOLD MAGENTA part numbers are new for 2025 AUDIO/VIDEO & MOUNTS PARTS-UNLIMITED.COM OFFROAD | 2025 125 DESCRIPTION PART # Handlebar/rail base for 3/4” to 1” dia. rails 0636-0060 Handlebar/rail base for 11/8” to 11/2” dia. rails 0636-0061 DESCRIPTION PART # Mini rail base for 3/8” to 5/8” dia. rails 0636-0059 RAM® MOUNT TORQUE™ HANDLEBAR/RAIL BASES WITH 1” BALL •Low-profile mounts are the perfect way to secure your personal electronics and small accessories in any high-vibration environment •Bases utilize nylon-insert locknuts to prevent loosening from vibration •Includes sizing inserts to provide a snug fit and rail protection DESCRIPTION PART # Spine clip holder w/ ball 0603-0821 RAM® SPINE CLIP HOLDER WITH 1” BALL FOR GARMIN® HANDHELD DEVICES •Easily clips into the integrated spine connection on a wide variety of Garmin® devices • 1” rubber ball •B-size diamond base adapter and hardware allow connection to any RAM® B-size mounting base DESCRIPTION PART # Ball accessory base for B-size socket arm 0636-0062 BALL ACCESSORY BASE ADAPTER FOR B-SIZE SOCKET ARM •The ideal accessory if you are looking to mount more than one device but cannot locate multiple mounting points on your motorcycle or vehicle •Connects another device to existing RAM® Mount • Includes 1” ball connecting to a 1/4”-20 threaded stud with a length of 1.6” •Threads on this ball replace the bolt in any B-size socket arm, and the ball connects to middle of socket arm on the opposite side of the tightening knob NOTE: Socket arm assembly not included. DESCRIPTION PART # RAM® Tough-Ball™ base 0636-0065 RAM® MOUNT TOUGH-BALL™ BASE • Features 1” diameter rubber ball connected to a 1/4”-20 x 0.25” male-threaded post •Male thread matches most standard camera and camcorder female threads found on the bottom of the camera DESCRIPTION PART # Brake/clutch reservoir base w/ 1” ball 0636-0142 RAM® MOTORCYCLE BRAKE/ CLUTCH RESERVOIR BASE WITH 1” BALL •Constructed of powder coated marine grade aluminum for added durability and strength in demanding conditions •Connects to handlebar clutch/ brake on left or right side •Base fits control clamps on motorcycle with 40 mm x 6 mm stainless steel hardware, provided in kit •Hole centers on base have a minimum width of 0.94” and a maximum of 1.58” DESCRIPTION PART # Brake/clutch reservoir base 0636-0058 RAM® MOUNT MOTORCYCLE BRAKE/CLUTCH RESERVOIR BASE WITH 1” BALLS •Mount electronic devices to your handlebar clutch/brake clamp • Holds two 1” diameter mounting balls •Ball that is connected between hole centers is removable •Includes 40 mm x 6 mm stainless steel hardware NOTE: To see if this base will mount to your motorcycle, check hole spacing of base against your clutch/brake reservoir.The holes’ centers have a minimum width of 0.94” and a maximum of 1.58”. 0636-0061
RkJQdWJsaXNoZXIy OTcxOTk3