BOLD MAGENTA part numbers are new for 2026 TOOLS & HARDWARE PARTS-UNLIMITED.COM SNOW | 2026 777 ANGLE PART # SHARPENING TOOLS 30° TOOL-SHARP3 45° TOOL-SHARP4 ANGLE PART # SHARPENING TOOLS (CONT) 60° TOOL-SHARP6 ANGLE PART # STUD SHARPENING INSERTS For 30°, 45° and 60° tools TOOL-INSERT-4 STEEL STUD SHARPENING TOOLS AND REPLACEMENT INSERTS •Easy to use – just put the tool into a 3/8” drill chuck and sharpen studs while they’re on the sled • Available in 30°, 45° and 60° angles •Replacement sharpening inserts also available; sold separately • Replacement inserts fit 30°, 45° and 60° sharpening tools and come in a four-pack DESCRIPTION PART # Indexing tool for support plates SPI-TOOL-5 INDEXING TOOL FOR SUPPORT PLATES •Fits on a standard 3/8” drive ratchet •For 5/16” square digger support plates •Use on installed square support plates to ensure their edges run parallel to the track’s edge DESCRIPTION PART # Shallow socket tool SCW-4505 SHALLOW SOCKET TOOL •A unique tool used for driving locknuts down on push-through studs •Provides the torque to tighten without touching the surface of the support plate •Will not scuff finish of colored support plates •Available in 5/16” size DESCRIPTION PART # Stud hex tool 3820-0007 DESCRIPTION PART # Repl. hex bits (2 pk.) 3820-0008 STUD HEX TOOL •Use this tool for installing and removing push-through studs •The handle is made from premium aluminum •Each tool comes with an extra hex bit •A replacement hex package is also available that contains two hex bits DESCRIPTION PART # Track marker TRAK-MARK TRACK MARKER •Use white marker to indicate stud placement •For use with Woody’s® studding templates •Check pattern before drilling holes DESCRIPTION PART # Track cutting tool FT-146 TRACK CUTTING TOOL •Superstrong cutting tool constructed of machined steel •Cuts a clean 5/16” hole and ejects slugs through machined slot in tool •Sold each ® DESCRIPTION PART # Pro Series backer installation tool 3820-0016 PRO SERIES BACKER INSTALLATION TOOL •Must-have tool for installing Pro Series backers •Tool is designed to hold the single Pro Series backer while installing the studs •Safely applies pressure to the backer and keeps it properly oriented for optimum results •Aluminum construction TOOL-SHARP3 3820-0007
RkJQdWJsaXNoZXIy OTcxOTk3