BOLD MAGENTA part numbers are new for 2026 PARTS-UNLIMITED.COM 2026 | STREET FUEL/AIR SYSTEMS FUEL/AIR SYSTEMS 1470 DISCLAIMER: *EMIS (EMISSIONS CATEGORIZATION CODE). SEE PAGES 4-6 FOR CATEGORY CODES, IMPORTANT EPA/CARB EMISSION DEFINITIONS AND REGULATORY COMPLIANCE AND NOTICE REGARDING NOISE REGULATIONS. PRODUCTS NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY POLLUTION CONTROLLED MOTOR VEHICLES IF NOT CATEGORIZED AS “1” OR “4”. DESCRIPTION PART # EMIS* POD-300 digital display 1020-2371 4 POD-300 DIGITAL DISPLAY •Real-time fuel adjustment • Display channels real-time: rpm,TP, map position (when using map switch), duty cycle, fuel exchange, ignition change and wideband air/fuel ratio (with WB2 or AutoTune connected) •Weather resistant for use in all conditions •Log channels saved to internal memory and can be viewed/analyzed with Dynojet’s powercore software • High-contrast display, viewable in sunlight •Includes CAN cable for attachment to Power Commander V,AutoTune and Wide Band Power Commander •Made in the U.S.A. NOTE: Not for use with Power Commander III USB. DESCRIPTION PART # For most Honda and Suzuki models 1601-0553 For most Kawasaki and Yamaha models 1601-0554 STANDALONE QUICKSHIFTER MODULES •Easy plug-and-play installation •No computer necessary for adjustment •Intellishift technology adapts while riding DYNOJET QUICK SHIFTER (DQS) SENSORS USB/V •Races are won or lost in fractions of a second • Dynojet’s Quick Shifter (DQS) kit allows full-throttle, clutchless upshifts in racing and performance riding applications •Shift rod pressure/tension sensor kit is a universal sensor that mounts to the shift rod in either a push or pull configuration; requires modification of gear-linkage tie rod •Linear travel sensor kit works with bikes that have no shift rod, or on those the shift rod sensor will not fit, by mounting one end to the shift lever and the other to a fixed point on the chassis; available in push or pull types with universal mounting hardware •Plugs directly into the Power Commander expansion port with no rewiring required •Power Commander Control Center software lets you set engine dead time during upshifts and minimum rpm for system operation • PART# 1601-0510 and 1601-0512 “pressure style” sensors for PCV/USB and have two terminals, so it can either act as “push” or “pull” type • PART# 1601-0014 is a “linear” sensor for PCIII USB • PART# 1601-0247 is a “linear” sensor for PCV NOTE: To order either of the above sensors, you must find the correct direction of movement during an upshift (push or pull). For the shift rod/pressure/tension sensor, press on the shift lever in the direction of an upshift to see if the rod is pushing or pulling on the clevis on the shift shaft. For the linear travel sensor, also move the shifter for an upshift. If movement is down, a pull sensor is needed. If movement is up, a push sensor is required. 1601-0553 1601-0014 1601-0512
RkJQdWJsaXNoZXIy OTcxOTk3