BOLD MAGENTA part numbers are new for 2023 V-TWIN TOOLS DRAGSPECIALTIES.COM TIRE & SERVICE | 2023 605 PART # DESCRIPTION SUG. RETAIL 3801-0002 Tappet screen plug tool $9.50 TAPPET SCREEN PLUG TOOL • For use on 70-99 Big Twin (except Twin Cam) with slotted screw tappet oil filter screen cover • Designed for use with 7/16” combination wrench to allow for maximum rotation without touching engine cases • O-ring design retains the tool in wrench or socket • Flange design allows downward force to be applied to tool • Can be used without removing exhaust pipes on most bikes • Tappets should be serviced every oil change PART # DESCRIPTION SUG. RETAIL DS-198638 For 70-99 Big Twin $39.95 TAPPET OIL SCREEN PLUG TOOL • Used to remove the tappet oil screen plug • Removes oil screen without removing exhaust • Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL 3801-0275 For all 99-17 Twin Cam engines and 00-20 XL and Buell (except 1125R) $74.95 TAPPET POSITION HOLDING TOOL • Safely stores anti-rotation pins and tappets for proper and accurate installation • Locations of the tappets are marked on the tool; prevents damage after being removed from the engine • Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL 3801-0261 For L76-17 Big Twin (except M-Eight) $39.95 TAPPET BLOCK/ OIL PUMP ALIGNMENT TOOL • Big Twin tappet blocks do not have counter-bored bolt holes; therefore, when a tappet block is removed (or even just loosened) it should be reinstalled using an alignment tool to ensure that the lifters track properly on the camshaft PART # DESCRIPTION SUG. RETAIL DS-197077 For L76-17 Big Twin (except M-Eight) $27.95 TAPPET BLOCK/OIL PUMP TO CAM PLATE ALIGNMENT TOOL • Used to align oil hole from crankcase to tappet block • Can also be used to align rocker box bases on Evolution head (requires two tools) • Aligns Twin Cam oil pump to cam support plate; two required • Sold each • Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL 3801-0410 For all Twin Cam and M-Eight models $59.95 MAGNETIC TAPPET HOLDERS • Easily hold the tappets in the tappet bores when the cam is removed • Install the tool over the tappet cover and the rare earth magnets will hold the tappet in place while performing any cam chest work • Includes a form-fitted tray to protect magnets from damage when stored • Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL 3801-0259 For 99-17 Twin Cam $86.95 ROCKER BOX ALIGNMENT SCREWS • Prevents misalignment of cover, compromising of seal and potential rocker interference • Sold in pairs • Made in the U.S.A. • This tool makes the process quick and easy, ensuring the durability of your installation • Tool also aligns Twin Cam oil pump to the cam support plate; two tools required • Sold each • Made in the U.S.A.
RkJQdWJsaXNoZXIy OTcxOTk3