BOLD MAGENTA part numbers are new for 2023 V-TWIN TOOLS DRAGSPECIALTIES.COM TIRE & SERVICE | 2023 609 PART # DESCRIPTION SUG. RETAIL 3801-0099 For all 07-17 Twin Cam, 06 Dyna Glide $145.95 PART # DESCRIPTION SUG. RETAIL 3801-0100 For 55-06 Big Twin (except 06 Dyna Glide) $145.95 ENGINE ROTATORS • Rotates flywheel/piston assembly with engine still in frame or on a bench • The perfect tool when doing pushrod adjustments, building big-inch engines and checking operating clearances • Also can be used to keep the flywheel assembly from rotating when torquing the cam drive sprockets retention bolts • Built with a long socket design,making it easier to use without a 1/2” drive extension on your 1/2” driver • Made in the U.S.A. NOTE: Not for use with an air or electric impact wrench; this tool is only guaranteed for use with hand drivers. 3801-0100 3801-0099 PART # DESCRIPTION SUG. RETAIL 3801-0200 For 55-06 Big Twin (except 06 Dyna); 10-spline $62.95 PART # DESCRIPTION SUG. RETAIL 3801-0207 For 06 Dyna, 07-17 Twin Cam; 24-spline $79.95 RATCHETING CRANKSHAFT WRENCHES • To rotate the crankshaft during engine timing and clearance checks • Offset design so it will not interfere with the motor case • Chrome-plated with EZ Grip screwdriver-style handle for comfort and more turning power 3801-0200 PART # DESCRIPTION SUG. RETAIL 3801-0196 For Big Twin engines (except M-Eight) $61.95 CRANKSHAFT BEARING ENDPLAY SETUP TOOL • For Big Twin engines to set up crankshaft bearing endplay • Diameter of the bolt is turned slightly smaller than the actual crankshaft diameter, allowing the inner bearing races to be installed and removed without pressing them on or off • Allows much faster changing of shims and faster setup time • Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL 3802-0070 For 14-21 Big Twin $18.95 COMPENSATOR BOLT TORX® SOCKET • Correct-style driver/socket for the compensating sprocket retaining fastener • Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL SS-B For Big Twin and XL $13.95 CRANKSHAFT JAM TOOL • Locks the crankshaft through the timing mark hole on the left • Enables timing and camshaft work to be done without the crankshaft moving from the timing mark line • Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL SS-C For 55-99 Big Twin (except Twin Cam) $52.95 CRANKSHAFT TURNING TOOL • Rotates the crankshaft; may be used while engine is in or out of the frame • Enables work on any part of the engine • Slides over the left side of the splined crankshaft • Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL 3801-0323 For 17-21 M-Eight $51.95 3801-0235 For 99-17 Twin Cam motors w/ crank position sensor 44.95 MIGHTY BITE FLYWHEEL LOCKS AND DECOMISSIONED TAG • Locks flywheel in place when performing service work to the connecting rods or pistons with the cylinders off the engine • Installs the case in place of the crank position sensor • Highly visible tag designates bike as decomissioned • Made in the U.S.A.
RkJQdWJsaXNoZXIy OTcxOTk3