BOLD MAGENTA part numbers are new for 2024 V-TWIN TOOLS DRAGSPECIALTIES.COM TIRE & SERVICE | 2024 609 PART # DESCRIPTION SUG. RETAIL 3801-0099 For all 07-17 Twin Cam, 06 Dyna Glide $159.95 PART # DESCRIPTION SUG. RETAIL 3801-0100 For 55-06 Big Twin (except 06 Dyna Glide) $159.95 ENGINE ROTATORS •Rotates flywheel/piston assembly with engine still in frame or on a bench • The perfect tool when doing pushrod adjustments, building big-inch engines and checking operating clearances •Also can be used to keep the flywheel assembly from rotating when torquing the cam drive sprockets retention bolts • Built with a long socket design, making it easier to use without a 1/2” drive extension on your 1/2” driver •Made in the U.S.A. NOTE: Not for use with an air or electric impact wrench; this tool is only guaranteed for use with hand drivers. 3801-0100 3801-0099 DESCRIPTION PART # SUG. RETAIL For 55-06 Big Twin (except 06 Dyna); 10-spline 3801-0200 $66.95 DESCRIPTION PART # SUG. RETAIL For 06 Dyna, 07-17 Twin Cam; 24-spline 3801-0207 $70.95 RATCHETING CRANKSHAFT WRENCHES •To rotate the crankshaft during engine timing and clearance checks •Offset design so it will not interfere with the motor case •Chrome-plated with EZ Grip screwdriver-style handle for comfort and more turning power 3801-0200 PART # DESCRIPTION SUG. RETAIL 3801-0196 For Big Twin engines (except M-Eight) $65.95 CRANKSHAFT BEARING ENDPLAY SETUP TOOL • For Big Twin engines to set up crankshaft bearing endplay •Diameter of the bolt is turned slightly smaller than the actual crankshaft diameter, allowing the inner bearing races to be installed and removed without pressing them on or off •Allows much faster changing of shims and faster setup time •Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL 3802-0070 For 14-21 Big Twin $20.95 COMPENSATOR BOLT TORX® SOCKET •Correct-style driver/socket for the compensating sprocket retaining fastener •Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL SS-B For Big Twin and XL $12.95 CRANKSHAFT JAM TOOL •Locks the crankshaft through the timing mark hole on the left •Enables timing and camshaft work to be done without the crankshaft moving from the timing mark line •Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL SS-C For 55-99 Big Twin (except Twin Cam) $48.95 CRANKSHAFT TURNING TOOL •Rotates the crankshaft; may be used while engine is in or out of the frame •Enables work on any part of the engine •Slides over the left side of the splined crankshaft •Made in the U.S.A. PART # DESCRIPTION SUG. RETAIL 3801-0323 For 17-21 M-Eight $56.95 3801-0235 For 99-17 Twin Cam motors w/ crank position sensor 49.95 MIGHTY BITE FLYWHEEL LOCKS AND DECOMISSIONED TAG •Locks flywheel in place when performing service work to the connecting rods or pistons with the cylinders off the engine •Installs the case in place of the crank position sensor •Highly visible tag designates bike as decomissioned •Made in the U.S.A.
RkJQdWJsaXNoZXIy OTcxOTk3